Boonton 4500B Peak Power Meter Manual de usuario descargar pdf (Pagina 47)

Boonton 4500B RF Peak Power Analyzer

Getting Started

3-13

Caution

When selecting a sensor for an exercise or a measurement, be sure you know the power range of the sensor.

esult in permanent change of

characteristics or burnout.

2. Connect the sensor to the sensor cable by aligning the red mark on each part and pressing the connectors together

firmly.

3. Connect the sensor cable to the Channel 1 input (holding the red mark UP).

When the sensor is connected, the instrument will download the factory installed calibration data from the sensor



the sensor is discon

When this occurs, (press CLR) to clear the error; reconnect the sensor.

In general, when any sensor error message occurs, disconnect and reconnect the sensor and press CLR. If the

message persists, refer the problem to Boonton Electronics for technical support.

Note The INIT key does not affect parameters selected for the GPIB Bus, RS-232, display colors, or the printer

configurations. It does not affect stored waveforms, setups or calibrations.

4 . Press the INIT function key to initialize the operating parameters listed in Table 3-3. This table represents all the

parameters that are affected by initialization. This table lists the value or the option to which the function will be

assigned after initialization.

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 371 372

Boonton 4500B Peak Power Meter Manual de usuario Pagina 47