Boonton 4500B Peak Power Meter Manual de usuario descargar pdf (Pagina 259)

Boonton 4500B RF Peak Power Analyzer

Remote Operation

5-59

READ:ARRay:AMEAsure:TIMe?

Description: Returns an array of the current automatic timing measurements performed on a periodic pulse

waveform. Measurements performed are: the frequency, period, width, offtime and duty cycle of

the pulse waveform, and the risetime and falltime of the edge transitions. For each of the

measurements to be performed, the appropriate items to be measured must be visible on the

display in GRAPH mode. Pulse frequency, period, offtime and duty cycle measurements require

that an entire cycle of the pulse waveform (minimum of three edge transitions) be present. Pulse

width measurement requires that at least one full pulse is visible, and is most accurate if the pulse

width is at least 0.4 divisions (20 pixels). Risetime and falltime measurements require that the

edge being measured is visible, and will be most accurate if the transition takes at least 0.1

divisions (5 pixels). It is always best to have the power analyzer set on the fastest timebase

possible that meets the edge visibility restrictions. Set the trace averaging as high as practical to

reduce fluctuations and noise in the pulse timing measurements. Note that the timing of the edge

transitions is defined by the settings of the SENSe:PULSe:DISTal, :MESIal and :PROXimal



Syntax: READ[1|2|3|4|6|7]:ARRay:AMEAsure:TIMe?

Returns: CC1, PulseFreq, CC2, PulsePeriod, CC3, PulseWidth, CC4, Offtime, CC5, DutyCycle, CC6,

Risetime, CC7, Falltime, CC8, EdgeDly, CC9, Skew in Hz, percent and seconds

` 

Valid Modes: Pulse mode only.

Restrictions: Timebase must be set appropriately to allow measurements (see above)

READ:ARRay:CW:POWer?

Description: Returns the current average, maximum, minimum powers or voltages and the peak-to-average

ratio of the specified channel. Units are th-to-average

ratio and marker ratio are returned in dB for logarithmic channel units, and percent for all other

channel units.

Note that the values for maximum and minimum power will depend on the peak hold mode; see

the description of the CALCulate:PKHLD command for details.

Syntax: READ[1|2|3|4|6|7]:ARRay:CW:POWer?

Returns: CC1, Pavg, CC2, Pmax, CC3, Pmin, CC4, PkToAvgRatio



Valid Modes: Modulated and Statistical.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 371 372

Sin comentarios

Boonton 4500B Peak Power Meter Manual de usuario Pagina 259