
Boonton 4540 Series RF Power Meter
Remote Operation
Table 5-1. SCPI COMMAND SUMMARY (continued)
MEMory[1|2]:SNSR:CFFAST? Return the sensor high bandwidth (FAST) frequency cal-factor
table.
MEMory[1|2]:SNSR:CFSLOW? Return the sensor low bandwidth (SLOW) frequency cal-factor
table.
MEMory[1|2]:SNSR:CWRG Return sensor AC cal data.
MEMory[1|2]:SNSR:CWSH? Return sensor smart shaping table.
MEMory[1|2]:SNSR:INFO? Return the sensor ID and parameter data.
MEMory[1|2]:SNSR:LFLIN? Return sensor smart shaping table.
MEMory[1|2]:SNSR:MESSage? Return the sensor message data.
MEMory[1|2]:SNSR:TEMPCOMP? Return the sensor temperature compensation table.
MEMory:SYST:LOAD Load saved instrument setup by filename.
<character data> = "USER1" ... "USER25".
MEMory:SYST:STORe Save instrument setup by filename.
<character data> = "USER1" ... "USER25".
OUTPut:EXTernal:LEVel[:POWer] Set or return the power level for an external 1 GHz calibrator
output signal.
OUTPut:EXTernal:MODUlation Set or return the output modulation state for the 1 GHz calibrator.
OUTPut:EXTernal:POLArity Set or return the polarity of the duty cycle in the preset pulse
control mode of the external 1 GHz calibrator.
OUTPut:EXTernal:PRESent? Return true if a Model 2530 external 1 GHz calibrator is connected
and powered up. Otherwise return false.
OUTPut:EXTernal:PULSe:CTRL Set or return the pulse control mode of the external 1 GHz
calibrator’s pulse modulator.
OUTPut:EXTernal:PULSe:DCYCle Set or return the duty cycle in percent in the Preset pulse control
mode of the external 1 GHz calibrator.
OUTPut:EXTernal:PULse:PERiod Set or return the pulse period in the preset pulse control mode of
the external 1 GHz calibrator.
OUTPut:EXTernal:PULse:PERWID Set or return the pulse period <arg1> and pulse width <arg2> in
seconds in the Variable pulse control mode of the external 1 GHz
calibrator.
OUTPut:EXTernal:PULse:SOURce Set or return the pulse modulation source for the external 1 GHz
calibrator.
Comentarios a estos manuales