Boonton 4530 Peak Power Meter User Manual Manual de usuario descargar pdf (Pagina 89)

4-15

Boonton Electronics Chapter 4

4530 Series RF Power Meter Remote Operation

TKSCWRG

Description: Returns the CW sensor linearity calibration table from sensor’s EEPROM. CW power

sensors have 7 pairs of upscale / downscale gain factors, and voltage probes have eight

pairs of upscale / midscale / downscale gain factors. Upscale factors have a nominal value

of 5000, and midscale and downscale factors have a nominal value of 0. On voltage probes,

the eighth pair of up/downscale factors and all eight midscale factors is returned at the end

of the array for compatibility with CW sensors.

Syntax: TKSCWRG?

Returns: numeric array: < DS0,US0,DS1,US1, ...DS6,US6 [,DS7,US7,MS0,MS1, ...MS7] >

Valid Modes: All

Restrictions: SYSTem:LANGuage must be set to BOON to use native mode instructions

TKSMSG

Description: Returns the sensor text message from sensor’s EEPROM. This message is programmed at

the factory or during sensor calibration.

Syntax: TKSMSG?

Returns: <Message String>

Valid Modes: All

Restrictions: SYSTem:LANGuage must be set to BOON to use native mode instructions

TKAVG

Description: Sets the talkmode to return the average power of the selected channel each time the 4530 is

addressed to talk. This is a “permanent” talkmode, and will remain in effect until a new

talkmode is set. Use this command in 4530 native mode for the fastest possible sustained

reading rate of single-channel average power over the bus. Power is returned in current

units.

Syntax: TKAVG

Returns: Average (or CW) Power

Valid Modes: CW and Modulated modes

Restrictions: SYSTem:LANGuage must be set to BOON to use native mode instructions

Special Case: If in ratiometric mode, reading will be in units of dBr (log) or Percent Power (linear).

1 2 ... 84 85 86 87 88 89 90 91 92 93 94 ... 169 170

Sin comentarios

Boonton 4530 Peak Power Meter User Manual Manual de usuario Pagina 89