Boonton 52000 Series USB CW Power Sensor Manual de usuario descargar pdf (Pagina 9)

Boonton 52000 Series 9

1 Installation Of Software

This chapter provides information about installing the Boonton

power sensor/meter software.

Before you start, please check your PC for software compatibility.

Refer to “Minimum PC requirements” on page 63 for more

information.

Install procedure

To install the Boonton software, follow these steps:

Caution Do not connect any hardware to your PC until you have

installed the Boonton software.

Note If you are using Windows XP SP1, disconnect any LAN

connections. This will prevent your PC automatically downloading

the wrong USB drivers.

Do this Comment

1. Insert the CD into your PC The installation should start automatically.

2. (Optional) If the installation

does not start automatically,

select Start > Run and type

d:\BoontonSensorInstallation.exe

Where D:\ is the name of your CD drive.

3. Select Continue Refer to Figure 2 on page 10.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 67 68

Sin comentarios

Boonton 52000 Series USB CW Power Sensor Manual de usuario Pagina 9