Boonton 52000 Series USB CW Power Sensor Manual de usuario descargar pdf (Pagina 51)

Boonton 52000 Series 51

7 Troubleshooting

This chapter explains how to x some typical software and hardware

conguration issues that you may have encountered. It also provides

some technical background information that can help you better

understand your test environment.

How to x “No Sensor Connected” problems

When you start your Boonton software application you can get the

following condition message displayed - “No Sensor Connected”,

refer to Figure 43 on page 51.

Figure 43 No sensor connected warning

This can be the result of one of the following issues:

• No sensor is attached to your PC (refer to page 52)

• The wrong USB driver has been installed (refer to page 52)

• The USB cable or USB port are faulty (refer to page 53)

• Incorrectly congured USB hub (refer to page 53)

• More than one application has been started (refer to page 54)

The following procedures will help you correct these problems:

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 67 68

Sin comentarios

Boonton 52000 Series USB CW Power Sensor Manual de usuario Pagina 51