Boonton 52000 Series USB CW Power Sensor Manual de usuario descargar pdf (Pagina 53)

Boonton 52000 Series 53

If this is NOT the driver listed in your Device Manager, then use the

following procedure to remove the installed driver and congure the

correct driver:

The USB cable or USB port are faulty

In the event of a faulty cable or port, try the following solutions:

• Replace the cable with another high standard USB cable.

• Use another USB port on your PC. If you only have one port on your

PC, connect another USB device to the suspected port (for example a

mouse or printer) and verify device recognition.

Incorrectly congured USB hub

Some USB hub devices require custom driver installation. If the driver

installation procedures are not followed correctly some, or all the

ports provided by the hub, may not be seen by your PC. Carefully

read your USB hub manufacturer’s instructions on driver installation

and conguration. If you are not sure the fault is with the USB hub,

try connecting a sensor directly to your PC and verify connection

using the application. Do this Comment

1. Disconnect any sensors connected to your PC.

2. On your PC, select Start > Control Panel.

3. Double-click on Add or Remove Programs.

4. Locate and select the FTDI COM driver listed.

5. Select the Change/Remove button. This removes the USB driver.

6. When the driver has been removed, close the Add or Remove

Programs dialog box.

7. Close the Control Panel.

8. To install the correct USB, refer to “USB Installation” on page 13.

1 2 ... 48 49 50 51 52 53 54 55 56 57 58 ... 67 68

Sin comentarios

Boonton 52000 Series USB CW Power Sensor Manual de usuario Pagina 53